Acopia Networks 810-0044-00 Manual de Instalação descarregar pdf (Página 179)

100

101

Adding a Direct Volume

Selecting a VPU (optional)

CLI Storage-Management Guide 8-23

Do this before the volume is enabled; once the volume is enabled (below), you cannot

re-assign it to another VPU.

For example, the following command sequence assigns the current volume,

“medco~/vol,” to VPU 1:

bstnA6k(gbl)# namespace medco

bstnA6k(gbl-ns[medco])# volume /vol

bstnA6k(gbl-ns-vol[medco~/vol])# vpu 1

bstnA6k(gbl-ns-vol[medco~/vol])# ...

Splitting Namespace Processing within a VPU

Each VPU has two domains, one per namespace. By default, volumes are assigned to

domains so that the domains run different namespaces. You can manually assign the

current volume to a particular domain, so that both domains have volumes from the

same namespace. (This option is more useful for managed volumes than direct

volumes; its use for managed volumes is discussed in the next chapter.)

To assign the current volume to a specific domain, use the optional

domain clause at

the end of the

vpu command:

vpu id domain domain-id

where

id (1-6) identifies the VPU, and

domain-id (1-2) chooses the VPU domain.

For example, the following command sequence explicitly assigns the current volume,

“medco~/vol,” to VPU 1, domain 2:

bstnA6k(gbl)# namespace medco

bstnA6k(gbl-ns[medco])# volume /vol

bstnA6k(gbl-ns-vol[medco~/vol])# vpu 1 domain 2

bstnA6k(gbl-ns-vol[medco~/vol])# ...

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 491 492

Comentários a estes Manuais

Sem comentários

Acopia Networks 810-0044-00 Manual de Instalação Página 179

Comentários a estes Manuais